Warp Feed on an Electronic Marker

[Enhander]

How would I go about getting a warp feed on an Ion? I got mine to work 100% with my Tac-One using the inteli-switch..but if I ever wanted to be crazy and put it on my Ion, how would I do that?

[PhoenixWolf]

Simple. Use the 90 degree feed adapter on the Ion's feed neck. If you don't have one, you can get one from various places, including AGD or proteamdirect.com. It's not ideal, of course, since the gun is still centerfeed, but it will work.

[Ruler_Mark]

How would I go about getting a warp feed on an Ion? I got mine to work 100% with my Tac-One using the inteli-switch..but if I ever wanted to be crazy and put it on my Ion, how would I do that?

splice the solenoid's wires and install a makeshift intelli feed cable

[Enhander]

Simple. Use the 90 degree feed adapter on the Ion's feed neck. If you don't have one, you can get one from various places, including AGD or proteamdirect.com. It's not ideal, of course, since the gun is still centerfeed, but it will work.

hehe I knew that part..im talking about getting the warp to actually recognize the electronics and spin on every shot

[Ruler_Mark]

splice the solenoid's wires and install a makeshift intelli feed cable

..

[secretweaponevan]

splice the solenoid's wires and install a makeshift intelli feed cable

^This. Then use the phone jack as described in the intelliframe to warp manual. It will either throw a positive or negative signal depending on which wire you tap. It doesn't matter which as you can set the input jumper on the warp. Done.

[Enhander]

^This. Then use the phone jack as described in the intelliframe to warp manual. It will either throw a positive or negative signal depending on which wire you tap. It doesn't matter which as you can set the input jumper on the warp. Done.

Gotcha...a little too much for what I wanna do..was just curious as to how to do it.
Thanks guys!

[paintball72]

blasphamy a warp on an ion.