Warp feed problem

[Snap32]

So i have this problem, My warp seems not to be able to push balls up with enough force to the feedneck. Now i was using reballs. is this the problem? because the warp seems to be just fine, got the 18v mod. Will post pics tommorow.

[211]

probably the reballs, they wont feed in my Qloader either
try it with real paint

[secretweaponevan]

So i have this problem, My warp seems not to be able to push balls up with enough force to the feedneck. Now i was using reballs. is this the problem? because the warp seems to be just fine, got the 18v mod. Will post pics tommorow.

It should be a 12V mod using 2 9volts. If you put more than 12V through the board you'll fry it.

If the discs aren't proving enough friction for the bore of paint you will be using (will have to un-do it if moving away from reballs), you can apply electrical tape to the discs to narrow the gap.