Question about fore grip. Tom please help.

[Predater]

I have a old school automagrt. Is there any way that i can get the finger groove grip on the front of the rt to be stationary. i dont want to glew it doun because i would like to be capable of posibly mooving it later on. But i dont care if it took me ten minuts or so to adjust it.

[max-mag]

Hmmmm, have you tried taking the main body off and messing the screw on the body rail, if that doesnt work, then what you say might be impossible.

[subbeh]

I know what he's talking about... I have a new RT (got it on closeout... cheap but new! yea!) and the rubber surround of the grip spinds with very little effort.

I wouldn't mind an easy solution, either... If one exists.

[AdrenalineMag]

ok, i tote a classic mag, but i think i see what you are saying... for an easy fix could you drill a hole thru the bottom of the rubber & the thing inside it & put some sort of pin or screw there to keep it from spinning? ddont be suprised if you dont understand this, im only guessing what the grip is like

[Predater]

the fore grip is gass through. there is a ruber sleve around it that was made to spin. i want a way to stop its spinning. drilling a whole through the side is impossible because you will drill in to the gass passage.

[AdrenalineMag]

i see... well news flash *DONT DRILL HOLES IN GAS PASSAGES!!* hehe, yeah well im not sure what ir really looks like so scratch that idea... hmmm... well im not sure what to do... good luck though

[Predater]

please help, anyone?

Help!

[[NA]WARLORD]

Adrenilins idea will still work, only dont drill all the way through. Just far enough that a set screw will go in and stop the grip from spinning. Or try putting a bead of silicone around the base (top/bottom), this will stop spinning of grip but also allow you to remove it if you need to later.

[Predater]

Thats a prety good idea. I may try to put it in betwene the ruber and aluminum so it will still look good. any one else with an idea?

[AGD]

Stick something in between the rubber and aluminum to open up a channel then drip in some superglue and that should hold it.

AGD