I just bought a new Tac one and i'm running a Smart Parts micro-max tank and reg. I just finished hooking up the air system to it and dry fired it a few times. It worked fine when I dry fired it with the exception of once where the trigger stuck in the back position for a sec. I was with my dealer at the time when it happened and he said it was normal. When I went to the field to get it chronoed it fired one and the trigger locked in the back position. What in the world could be the cause. I just bought the gun (new), and it has been fired only one while being chronoed.
-
-
Got oil? -
yep my dealer put a few drops in.Originally posted by Spider-TWComment
-
try loosening the field strip screw
it should only be hand tight
my guessComment
-
I would start with that also.Originally posted by 211Comment
-
I was under the impression the micro max flow had a much lower psi rating 800 tops, with the lvl 10 I think you may be starving your marker.Comment
-
The micro is a 850 psi preset.Originally posted by gunangelComment
-
i would go and take the Valve out remove the ON/Off Oil the hell out of it. Kinda sounds like your tuning is maybe off too. But Mags love Oil....lolComment
-
You are getting bolt stick. Remove all the powertube shims. Go to the next larger carrier using the same white oring you are using now.
It could also be a ULT problem if one of those is installed. Is there a ULT?Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
Remove the valve. Can you slide the bolt on the powertuber easily? If not, remove oring, place oring in the next carrier larger.Comment
Comment