Information needed

[vikking_1]

can anyone give me more information as to What This Is and what it does, thanks.

[warchild69]

Yeah i had seen that on ebay a few times too. it looks like the back half of a valve, where the velocity screw screws into. other than that, i have no clue

[secretweaponevan]

can anyone give me more information as to What This Is and what it does, thanks.

It replaces the back half of the AIR valve unless I'm mistaken. Like most aftermarket parts for mags, it won't provide any substantial performance increase.

[vikking_1]

thanks

[Nick E]

From what I've heard, Air America Armageddon regs are essentially the rear end of an automag. Right down to the threads. Though apparently neither of the two companies cared about this.

[2BAD4U]

can anyone give me more information as to What This Is and what it does, thanks.

<a href="http://s73.photobucket.com/albums/i231/Majickcracker/?action=view&current=fluxcapacitor2.jpg" target="_blank"><img src="http://i73.photobucket.com/albums/i231/Majickcracker/fluxcapacitor2.jpg" border="0" alt="Flux capasitor"></a>

[flyingpootang]

It replaces the back half of the AIR valve unless I'm mistaken. Like most aftermarket parts for mags, it won't provide any substantial performance increase.

Mmmmm, It's actually the lower half of a Air America Violator regulator. It will not work on an AGD valve....

[michbich]

Mmmmm, It's actually the lower half of a Air America Violator regulator. It will not work on an AGD valve....

It could work. Some regs have the same threads as the AGD back regulators. I know the ans gen x2 reg fits as a back half.

[vaultman]

It, is as mentioned above. you'll find many companies using similar Tom K designs in their guns. They just try to copy the best.