Factory work question.

[Swampy]

I know I can send my valves (RT Pro valve and AIR valve)back to the factory to get work done. But I have a few questions.
1. Is the address current on AGD's home page?
2. Should I just send the valves or should I send the marker with it?
3. Can they repair a aftermarket part as well? I broke off the battery cable in my hyperframe board and I don't mix well repairing electronics.

The only brick and mortar paintball store is about 20 miles away and they have always been kind of shady to me so I won't just give it to them to fix. The problems I have with my AIR valve is just won't seal up. I've tried replacing all the o-rings, tried all my lvl 7 spacers, turned up and down the velocity, and I got nothing. My RT Valve the power tube unscrews and separates from the valve body, and my lvl 10 needs a good tuning.

[secretweaponevan]

I know I can send my valves (RT Pro valve and AIR valve)back to the factory to get work done. But I have a few questions.
1. Is the address current on AGD's home page?
2. Should I just send the valves or should I send the marker with it?
3. Can they repair a aftermarket part as well? I broke off the battery cable in my hyperframe board and I don't mix well repairing electronics.

The only brick and mortar paintball store is about 20 miles away and they have always been kind of shady to me so I won't just give it to them to fix. The problems I have with my AIR valve is just won't seal up. I've tried replacing all the o-rings, tried all my lvl 7 spacers, turned up and down the velocity, and I got nothing. My RT Valve the power tube unscrews and separates from the valve body, and my lvl 10 needs a good tuning.

In your case, I'd send the valves back, especially the RT that unscrews, unless you feel like using blue loc-tite on it.

Airgun Designs USA
401 Florine Court
Cary, IL 60013

should be correct. I'd call first to let them know to expect a package.

As for the hyperframe, call up an RC shop or similar electronics shop. Should only be a $10 repair.

[Swampy]

In your case, I'd send the valves back, especially the RT that unscrews, unless you feel like using blue loc-tite on it.

Airgun Designs USA
401 Florine Court
Cary, IL 60013

should be correct. I'd call first to let them know to expect a package.

As for the hyperframe, call up an RC shop or similar electronics shop. Should only be a $10 repair.

Cool thanks for the info. So its just the valves they want?

I got a RC/hobby store thats close, they do have a paintball section but its limited and some pretty cocky kids behind the counter that thinks he is king poo about paintball (Until I showed him a mag)

[paintball72]

just take in the harness, you dont even need to show it to king poo but just ask someone if they can reatach the wires to the plug (im asuming they pulled out) and they should be able to do that for you.

[secretweaponevan]

Cool thanks for the info. So its just the valves they want?

I'd send the whole marker, unless you don't have another frame for the hyperframed one.

[Swampy]

If its going to take about ten minutes to fix then I'll just have the frame fixed then send it in with the marker.