This is, of course, for my pneumag. I setup my bench today, ran through a few different builds since my pneumag is not built the same way as most others with the barbs pointing downard. My plan is to glue one magnet down to the barb closest to the lever, then the other magnet to the inside of the lever.
After figuring out all this I sat down and compared the two placements of the magnets. Unfortunately I wasn't able to think up an easily adjustable mount so I need a method that will always be consistent. A repelling setup will, ideally, reduce shortstroking by quickly resetting the trigger. Attracting magnets will shorten the pull by reducing the trigger pull distance, yes?
Assuming I'm right, which setup would work best in one set position? I bought a pack of radioshack rare earth magnets so they're pretty strong but also not as small as Dueydog's, the ones you see in Cyberrave's installations.
After figuring out all this I sat down and compared the two placements of the magnets. Unfortunately I wasn't able to think up an easily adjustable mount so I need a method that will always be consistent. A repelling setup will, ideally, reduce shortstroking by quickly resetting the trigger. Attracting magnets will shorten the pull by reducing the trigger pull distance, yes?
Assuming I'm right, which setup would work best in one set position? I bought a pack of radioshack rare earth magnets so they're pretty strong but also not as small as Dueydog's, the ones you see in Cyberrave's installations.
Comment