Sleeper on/off

[mag79]

I am trying to build a sleeper pneumag. I drilled and counterbored my direct mount cp on/off to match the bottom of my airwalk frame. My question is, how is the air suppose to reach the middle of the cp on/off? Its an unsealed area. Did I miss something?

Just notice my mistake, I drilled in the wrong location. I will post up a how to once I am done. It seems that all this infor dissapeared.






BTW, the cp was taken apart before any drilling was done.

[mag79]

Just notice my mistake, I drilled in the wrong location. I will post up a how to once I am done. It seems that all this infor dissapeared.

[chafnerjr]

Let me know how this goes. I am doing the very same thing with an airwalk v2... have you milled any extra from the bottom of the inside of the frame? I think I am going to have to because the threads on my tickler aren't even close to long enough to get into the CP on/off.

[questionful]

I thought the LPR screwed into the frame and an O-ring sealed the air passage between the frame and ASA?

[mag79]

I thought the LPR screwed into the frame and an O-ring sealed the air passage between the frame and ASA?

it does