quick e-mag pin question

[dark blade]

I was previously using a tac-one with xvalve and all the goodies... however, now i have emag lowers and I know i need a shorter .712 pin

My question is, can i use the same on/ff assembly from the xvalve and just shave down the current pin? or do i need to buy a special emag lowers on/off assembly with pin

[Geronimo7]

Yes you can use the standard r/t on off. Shaving the pin is probably not recomended, but you can do it if you have a good set of digital calipers.

[dark blade]

ok main reason i asked was cuz i checked AGD's site and they dont have any more pins in stock


anyone have any other ideas besides tunaman?

[questionful]

I would shave the pin down. Just keep checking with the calipers until you get it down to .712 little by little.

But if you want to buy one, just ask for one over in the B/S/T

[dark blade]

ok i successfully shaved the pin down to .7" because i read that it gives the most reactivity and fastest speeds on all the 3 modes (electro, hybrid, mech)

however... i just realised that if you turn the safety on you can noid click... i never knew this and was surprised that everyone i asked said you cant noid click

is this bad for the gun and is .7" too short? were the people lieing?