Well i got a BKO frame a long long time ago, and it's shaped much like Rogue's newest trigger frame. Well anyway i drilled out the front mount hole and drilled out the back one to fit my RT, and i got it for 10 bucks shipped and all so i was hoping to use that instead of my Intelliframe. Well long story short, with how i have everything drilled the MPA-3 (the part with the piston) has the barb sticking out where the trigger is. If i move it forward i have to heavily modify it and it'll only be half on the back field strip screw which i won't feel safe about, but it'll be right behind the trigger and i'm also afraid that'll make it so it won't go all the way. I know people have used BKO frames for this, so i was wondering if someone could post a picture, because i really don't want to mess up my intelliframe.
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.