mech emag + warp?

[dark blade]

Ok this is a very straight forward question and I know it is probably stupid and easy to answer but I have an emag and I use the warp cable for my warp... however, I wish to use my emag in mech mode (not hybrid or electro but straight mech) and I don't understand how I am supposeto get the warp to advance after every shot.

Is my only way to put it on sensor mode instead of using the cable?

I really don't want to give up the syncedness of the cable

[MANN]

Is my only way to put it on sensor mode instead of using the cable?

I believe that is the only way to use it in pure mech mode.

[maniacmechanic]

at one point I had one set up the same way , plug in cable at the warp right ?
IIRC put a jumper in the sensor port and it will work when the E Mag battery is off

[dark blade]

Well... I will have to try that.

However, I lost the springs for the sensor so I am kind of screwed on that and I do not want to spend $9 on shipping from agd.

Any ideas where I can get them elsewhere? Homedepot? Online store?

And how do I adjust the sensitivity I am not sure how to do this on my warp

[MANN]

Well... I will have to try that.

However, I lost the springs for the sensor so I am kind of screwed on that and I do not want to spend $9 on shipping from agd.

Any ideas where I can get them elsewhere? Homedepot? Online store?

And how do I adjust the sensitivity I am not sure how to do this on my warp

springs?

you adjust the sensitivity with a pod that is under the back plate. there is only one iirc.

[dark blade]

yes you adjust it with the rotating blue thing which i found... however... in order to make the warp work in vibration mode you need the 2 contact springs that go under the board. And i lost these two very small springs.

So now i need to find some other manner of using it because i dont want to pay $2 for the springs and $7 for shipping.

[Beemer]

Well... I will have to try that.

And how do I adjust the sensitivity I am not sure how to do this on my warp

http://www.airgundesignsusa.com/manual.shtml see the warp manual here

[dark blade]

ya i figured out where the blue thing was and i know how to adjust it... but the two springs for under the board are missing and have been since i bought it.

anyone have any extra springs i could buy or they could give up for free?

[ThePixelGuru]

I'm not totally sure you need those springs. I seem to recall getting my Warp to work without them, though I'm not sure about that. It was a while ago, and I don't still have the warp to test that...

[dark blade]

well i dont see how the sensor would work without them... its the only way you can transfer the vibrations from the sensor to the board

any idea if i can buy some standard springs from a homedepot that fit and if they will work?