Warp feed mounting

[[HS]Div]

I just purchased a warp feed and I cant seem to get it mounted to my sp1 can any one tell me what i have to get to mount it. Its a basic Smart parts Sp1 With A basic warp feed package.

[FiXeL]

Do you have this bracket?



If not: http://store.airgundesignsusa.com/in...&categoryID=19

It mounts under the gripframe between your grip and asa.

[[HS]Div]

Yes. But it seems that I cant mount it with the screws provided

[FiXeL]

Are the screws too short? If thats the case then you can get longer ones from a local hardware store. 10-32 UNF is what you need.

[BlueMagRT]

I could recommend this nice kit

ProTeam Products

It's a bit expensive but it is universal and will adapt to any marker out there.

[[HS]Div]

I replaced the screws but I am still having problems mounting the hose on the gun. The warp feed bracket is finally mounted but the tube wont connect to the sp1 the feed neck is the wrong size.

[Ravenneon]

There should have been a right angle piece with the kit---the tube itself will not fit onto the actual feed tube itself-the right angle piece will have a philips head screw to tighten or loose it to fit on the feed tube

[[HS]Div]

The angle piece will not fit on my feed neck it is too small.

[[HS]Div]

So the right angle mount for the feed neck is too small to atach to my feed neck. I have a 1" outer diameter. And the feed angle mount is just too small. What can i do