I was wondering if an E-mag on/off assembly will work in an X-valve? Or, do I have to just replace the on/off pin in the RT assembly that is already on the valve?
Thanks!
Thanks!
-
-
Yes you can use your current r/t on-off. You only need to replace the pin with a .712 pin and change out one o-ring with the quad o-ring. -
This is the o-ring you will need
it replaces the smaller of the two in the top of the on/off
AGD sells them in packs of 4, but you could probably get a single one from Tuna along with the .712 pin.Comment
-
Thanks!Comment
-
From my own experience, I found this to make my X-Valve highly reactive. Since the pin is shorter, it requires a shorter trigger pull and gives as much return force as an RT.
My DXS tank only puts out about 800psi and I easily sweetspot the trigger with a respectable cycle rate.Comment
-
true fact... i run a HP myth and its preset to about 900, but since its a myth it has a great flow... much better than any other tank reg
and i can get extreme bounce in hybrid and mech mode
its wonderfulComment
Comment