I just got a set of emag lowers and I got a tunablade with it. I am pretty happy with it so far but I was wondering if there was a way to adjust the trigger movement. In both mech and electronic mode it takes a bit of travel to get to the firing position and I just wanted to tighten it up a bit. I tried looking at the AGD emag manual but there is nothing there to help. Do I just need to get a grub screw and tap a top trigger stop or is there a built in method? Again I have never owned an emag before so any tips would be great. (it has already been flashed with the xmod and it fires just fine, I just wanted to get it a little closer to perfect)
-
-
no need to tap it,
if you take the body and rail off the mag and look down at the top of the lowers... the fire select switch on the inside there is a hole tapped on top with an adjustment screw. that should take up the slack on the top of the trigger, and on the back of course just adjust the magnet distance accordingly. -
Simple
Thanks I appreciate the help.
Yeah, that was really easy. I actually hadn't taken it apart yet and was looking for an easy answer from the forum. If I had just opened the shell I probably would have seen how the emag actually functioned and would have possibly figured it out (I think). Thanks for the quick solution though. Like I said, so far this is my first emag. I've only owned classic, x-valve, and pneumags (and a boo-yah but...). Figured I should branch into the nicer electro mag market.Comment
Comment