Twist Lock Barrel Conversion

[rifleman wi]

anyone do, or know if its possible to convert a HL/HR barrel to CF?

[questionful]

If there isn't a channel where the twistlock pin would be were the breech facing up as it would be in a CF configuration, yes. But I don't think that's the case. You could always try JB weld'ing up the existing channels and just making new ones. Just don't be an idiot like I was; I converted a dual-nubbin HL to a HR with a dremel but left a little hole in the channel (I went too deep).

[automikey]

If you don't need to remove the barrel often you can just drill a small indent where needed and then assemble the marker with the barrel. Just no more twistlock.

[rifleman wi]

If you don't need to remove the barrel often you can just drill a small indent where needed and then assemble the marker with the barrel. Just no more twistlock.

that or i was thinking a new hole for the paint to drop into could be drilled out on the top.