CP ASA disassembly/adjustment

[GoatBoy]

Does anyone know how to adjust one of these ASA's?



For some reason, mine went out of adjustment today and wouldn't properly press the pin valve in when screwed in. I managed to get it working, but it was starving my gun all day. It's worked fine before, so something must have gotten jarred recently.

How do I get in there and adjust that pin travel?


Thanks!

[Ruler_Mark]

needle nooser's take the center brass piece out, then it is very logical i forget the exact steps.

[Sanchito]

thats weird.

mine is leaking air out the bottom through the bleed hole, and will never quit. i also cant figure out how to stop it.

[Dewok82]

http://www.customproducts.us/downloads/maintenance_guide_2k5_on-off.pdf

http://www.customproducts.us/downloads/maintenance_guide_dm_on-off.pdf

[GoatBoy]

Doh, why didn't I think of that. Thanks for the links.



Hrm... so, apparently, there isn't anything to be adjusted. Which leaves me wondering why the thing started acting up today...

[Dalm]

thats weird.

mine is leaking air out the bottom through the bleed hole, and will never quit. i also cant figure out how to stop it.

Not sure this is the issue but 8 times out of 10 a leak through the bleed hole on the bottom is a bad o ring on the tank. Check it for nicks or deformities

[Dalm]

Doh, why didn't I think of that. Thanks for the links.



Hrm... so, apparently, there isn't anything to be adjusted. Which leaves me wondering why the thing started acting up today...

check the o rings. they are always the culprit!!!!