So I was working on my new Micro this morning, trying to finish pneuing it, and the sear pin just fell out. I've only played with it only once so far but I had my benchmark frame on it which has wings and held the pin in place. Now that I'll have my intelli on there, I really don't have anything to hold it in. It falls out really easily too, you just have to tilt the gun and it slides out on its own. I just put a piece of tape over it for right now, but does anyone have any experience with this or have any suggestions as to how to keep it from falling out when I'm using a trigger frame without wings? Thanks.
Comment