Problem with electronic(emag lowers)

[BenoitOWN]

When I plug my battery now, the screen only show 1 letter then it goes off. I thinked at first it was the batery but I charged it back and it still do it. I changed the stock trigger to a tunablade and since then it did that.

Any idea of what it could be?


Update: The screen work back but I dont hear the noid fonction.

[BigEvil]

You probably have the magnet too close to the HES. Back it out a tad and try it.

[BenoitOWN]

It still do it even if I screwed the magnet the most inside the trigger. It a brand new magnet.

Oh and it not the screen the prob because I checked it with red stock one and it still do it(even had 2 pin IN my finger after having the red back out)

[BenoitOWN]

You was right the magnet is too close, I move the HES more away from the trigger and it worked normal. So I guess that I need to take the old magnet for it to work?

[BigEvil]

You cant just adjust the trigger magnet to move it away from the HES?

[BenoitOWN]

Now it my solenoid who dont want to work. I dont hear it clic.

[BenoitOWN]

charged a brand new battery and it still dont work. I checked connection and they seem to be ok ... how can the noid be killed like this?

[Madmarx]

Are you sure the trigger magnet isn't backwards?

[BenoitOWN]

Do the same thing with the old magnet of the stock trigger.

[mostpeople]

I just fixed this problem the other day.

Here is what is happening, your gun is turning on, and recieving a signal from the H.E.S. that the user is firing the marker because the trigger magnet is too close to the H.E.S. sensor.

The remedy for the situation is to move the trigger magnet FARTHER AWAY from the H.E.S. and try to reboot.

Good luck

[BenoitOWN]

It working for now, when it will get fully installed it shoud be great! Thx for the help