E-mag- bouncing in mech, not firing on E

[nate2k191]

e-mag with x-valve, e-mag on/off with quad o-ring.

air up, usually fires a shot automatically.

pull trigger in mech mode - shoots more than one shot per pull

pull trigger in hybrid - shoots more than one shot per pull

pull trigger in elec - does not fire, solenoid registers, i hear it try to activate, batt charged.

i can't get it to stop bouncing in mech mode. and i can't get it to shoot in e-mode... i've replaced o-rings, on/off pin, oiled, changed LX spring, changed plunger length... idk.

[Ruler_Mark]

do you have a caliper to verify lengths of parts?

[nate2k191]

do you have a caliper to verify lengths of parts?

i'll go to home depot right now to get one, can you list the lengths please.

[olinar]

E-Mag:

On/Off pin: .712" w/ brass top and double o-ring top.
.725" w/ aluminum top and single o-ring top.

Trigger Rod: 2.125"

Solenoid Plunger Rod: 3.005"

[nate2k191]

pin measures right, so does the plunger.

[flyingpootang]

use a .750 pin, whats your dwell or fix at?, make sure your noid rod length is correct and not bent., make sure your ground is clean and secure......

[nate2k191]

use a .750 pin, whats your dwell or fix at?, make sure your noid rod length is correct and not bent., make sure your ground is clean and secure......

tried a .750 pin, would fire 1 shot, then sear would stick, in mech mode. no fire in E.

[secretweaponevan]

tried a .750 pin, would fire 1 shot, then sear would stick, in mech mode. no fire in E.

Does your board stay on or does it short out in E mode?

Can you pop the valve in a different body to make sure that it works and this is just an E issue?

[flyingpootang]

Have you checked the battery voltage and any recent work to the marker?

[nate2k191]

Have you checked the battery voltage and any recent work to the marker?

voltometer is not with me right now. not sure.

[flyingpootang]

tried a .750 pin, would fire 1 shot, then sear would stick, in mech mode. no fire in E.

Sorry I forgot to mention with the .750 pin use the smaller white on/off o-ring instead of the quad. A mag will go full auto when the pin is too short. I'm also betting the battery voltage is under 16.8 volts....

[Ruler_Mark]

tried a .750 pin, would fire 1 shot, then sear would stick, in mech mode. no fire in E.

DO NOT use a emag with a .750 pin. where is the .712 pin?