Which vavle do I have? Want to upgrade

[orrangexiii]

I hope this isn't a dumb question but I just bought a RT Pro and I don't know which valve I have. I would assume it is a Retro Valve but I'm not sure. I know its not an X valve. So then it must be the ReTro Valve. I am planning on upgraging to a Level 10 and a ULE Trigger Pull kit. So from what I gather I will be able to drop in both upgrades or am I mistaken? The back of my valve is gray with a white RT pro engraved on it and the front is stainless. Any help/info is greatly appreciated. Thanks

[xero28]

Not a dumb question. It is an RT valve, which is essentially an X-valve. Two differences between X's and RT's, X-valves are all aluminum whereas RTs are 1/2 alum, 1/2 stainless. The other difference is that not all RT's will accept the ULT on/off, and all X's will. You will have to check the on/off hole in your valve. If there is a small ledge at the bottom, it will not accept the ULT, no ledge and it will accept it. Or you can check you're on/off assembly. If it uses one o-ring on the top (the part furthest away from the sear), then no ULT. Two o-rings and ULT OK. If yours will not accept ULT, you can send it away to Tunaman to have it milled out. The level 10 will work with any and all valves made by AGD (except for field rental valves, don't ask me why), so it will work with yours, it will just have to be tuned. Good luck, and have fun with it.

[MANN]

(except for field rental valves, don't ask me why),

because they have an orfice in the powertube tip that the lvl X bolt will not fit into(it has a longer tub in the middle of the bolt. This is a quick fix with a drill.

just FYI

[TeamJackal37]

it's a RT Pro not RT