Alright I have programmed all of my emag/xmags with xmod, agd4.01, etc. I use to use my wifes computer to do this. Recently we put a new hardrive in her pc so I lost all my programs. No big deal. I had the software downloaded on my jump drive so I installed it on my pc.
I downloaded the avr studio and the drivers. Everything looked what I thought was normal.
I hooked up my emag like I always do and chose the program I wanted to load. When I hit program It stated that the program was too large do I want to install? I hit yes and it acted like it was installing like normal.
After this nothing flashed on the emag led. (kinda odd because it normally says beta 1.8 blah blah.)
So I think I may have a bad file and I grab my "golden gun" flash and try to flash it. It comes up with a message that the board cannot be eraised.
WTF. Am i missing something? I am deleting all of my atmel programs, and reinstalling them from the website. I am also going to reinstall the xmod programms from the xmod website.
Could I have fried the board? there are no lights working, and it is acting stupid.
Any help?
I downloaded the avr studio and the drivers. Everything looked what I thought was normal.
I hooked up my emag like I always do and chose the program I wanted to load. When I hit program It stated that the program was too large do I want to install? I hit yes and it acted like it was installing like normal.
After this nothing flashed on the emag led. (kinda odd because it normally says beta 1.8 blah blah.)
So I think I may have a bad file and I grab my "golden gun" flash and try to flash it. It comes up with a message that the board cannot be eraised.
WTF. Am i missing something? I am deleting all of my atmel programs, and reinstalling them from the website. I am also going to reinstall the xmod programms from the xmod website.
Could I have fried the board? there are no lights working, and it is acting stupid.
Any help?
Comment