In the past few days I took my Tac 1 and RT apart for cleaning. I reassembled them, then aired them up. Both guns wont shoot. The rt sears, rt on/off pins are to specs and the x valves are set to 280fps from my last game. I removed the trigger frames and just assembled the body, rails and valves. When I air up the guns this way I can move the sear with my hand and fire them. I am I doing something wrong when I install the trigger frames?
-
-
How far appart is the trigger from the trigger rod when aired? It should be 1mm. -
Did you accidentally swap a rail, frame or sear?Comment
-
check tightness of frame & field strip screwsComment
-
The rod went over the safety pin. Just take the trigger frame off and be sure it doesn't go over when you re-assemble.Comment
Comment