Triggers on Micromags?

[Vomitsquad]

Could you slap on any aftermarket blade trigger on a 2-finger Micromag frame?

[Vomitsquad]

Nobody? This must be quite a n00b question so someone out there gotta know, right?

[Dend78]

Nobody? This must be quite a n00b question so someone out there gotta know, right?

i believe it can be done without any problems but there may be some modification that needs to be done, i mean there is the good ol saying have dremel will fit lol, let us know what you come up with

[Vomitsquad]

I have access to a fully equipped workshop so i could probably mill anything to fit.

I whould prefer a drop in solution so i won't have top re-ano it aswell. Got too many projects as it is but maybe i'll give it a go...

[michbich]

What kinda trigger frame are we talking about?

I'm looking a my hyperframe and benchy, they won't fit. The pivot points are not at the same location.

[maniacmechanic]

I would have " thought " a Benchy trigger would fit

[Coralis]

I'm pretty sure the micro mags used a benchmark frame , not sure if after market triggers were made for them though .... you could try emailing tracey at ptp products to see .

[michbich]

I'm pretty sure the micro mags used a benchmark frame , not sure if after market triggers were made for them though .... you could try emailing tracey at ptp products to see .

There was the Medussa trigger for the Benchy if I remember correctly.