RT mag leak help

[madrox68]

ok my rt mag is leaking down the barrel. its leaking thru the power tube. any suggestions?

[jrod]

Level 10 or level 7 bolt? I'm guessing the o-ring in the power tube.

[madrox68]

Level 10 or level 7 bolt? I'm guessing the o-ring in the power tube.

lvl 10

took it all apart oiled it and none of the rings were obviously bad, may just go and replace all the reg seat o-rings, unless theres a easyier way

[madrox68]

so whats the deal with white o-rings? the ones i pulled out were slightly translucent.

[211]

try going down carrier sizes until it stops, but use the largest one that doesnt leak

[jrod]

try going down carrier sizes until it stops, but use the largest one that doesnt leak

Make sure you use the same o-ring when switching carriers (there's a break in period).

All the answers to your questions are probably here:
level 10 guide

[madrox68]

try going down carrier sizes until it stops, but use the largest one that doesnt leak

not try to sound sarcastic but im sitting here looking at roughly 5-6 o-rings of various size and placement going. HUH?

[Coralis]

Level 10 installation vid http://www.youtube.com/watch?v=V0mvr30jKhw

[madrox68]

ah got ya. im with yall now. will have to replace these at the feild tommorow. and i do believe im missing a shim. how important is that?

[jrod]

If it works with one shim you're good to go.

From the level 10 guide:
If you find that when you pinch a ball the marker locks up and does not reset then add another shim.

Therefore, stick a squeegee in front of the bolt and pull the trigger. The level 10 should stop on the squeegee, and then reset.