centerfeed barrel modification

[Smoothice]

So I finally got ahold of twistlock freak back. And of course it is for a centerfeed body. My body is not a centerfeed.

So i'm wondering if the best course of action would be to just drill a new indention where I need it and fill in the remaining slot with jb weld so that I don't over twist past my new hole.

Here is a great diagram to show what I want to do.



What say you???

Here it is on my marker just for giggles.

[BigEvil]

Just make a new notch.

[Smoothice]

notch as in indention?

Or a new slot?

[BigEvil]

notch as in indention?

Yup, ive done a bunch of them. Make sure it lines up right, then use a drill bit to make the indentation. Fairly simple.

[Smoothice]

Yup, ive done a bunch of them. Make sure it lines up right, then use a drill bit to make the indentation. Fairly simple.

Think I should bother filling in the un-needed slot? Our is just the indention sufficient?

Thanks!

[BigEvil]

Think I should bother filling in the un-needed slot? Our is just the indention sufficient?

Thanks!

Just make the indent and dont worry about filling in anything. Hopefully you wont need to make another slot to get the feed holes to line up