need some Booyah Elcd info.

[Ratzo]

I picked up a Minimag for a project gun, and it came with a BooYah frame.
It had been tested at the shop and was working great when it first came in.
Then one of the nit wits that hangs around the local shop was messing with it, and ended up pulling out the 9v harness.
just need to find out which way the wires go back into the plug.

[pump]

theres a plug in the board for it, just put it back in, if you have trouble ill take a pic...but it will take a while

[MANN]

sell it and find something else. That is the only info I can give your. Boohyaah frames are very finicky.

[pump]

mine works amazingly well

just i would like modes and better bat efficiency
i might buy a new board for another frame...maybe UTB or anything with an adjustable dwell of 2msish

most of the problems i see with them is the on off not being installed properly, the on off pin was very small, with a tighter oring it works fine