Issue EP mag with ion board

[ezcreation]

I have an ion board interacting with a mpa-3 and everything is running. That said with maximum air from the LPR it still doesnt strike the sear hard enough to shoot.
Any suggestion?

Thank you

[captian pinky]

ule trigger pull kit

[ezcreation]

ule trigger pull kit

Already done

[MANN]

change the time that the noid is open.

[rastamag]

Dwell!! Check Your Dwell

[ezcreation]

exactly what I was thinking about
More info soon

[captian pinky]

add more shims

[Hilltop Customs]

dwell and possibly move the mpa3 down on the sear to gain a larger lever arm.....means less pressure required for the same force on the on/off.


On another note, if you havent done some mods to the ion noid the ram will be charged all the time and then release when you pull the trigger. This is the opposite to the way an ep mag normally works, but theoretically still should function. This also means the dwell is effectively the trigger release, not the trigger pull.

[ezcreation]

Fully works guys.

MAxed out the shims on the ULT to make it super sensitive and it is simply ripping. Now I am at the point where I adjust dwell and ROF to optimize the xvalve. But that things rips it s insane!