Micromag woes... ARGH?!

[ajnin]

Ok so I recently purchased a micromag...


I have been working with mags for many years now and have a decent understanding of the hows, and whys. but for whatever reason.... this mags issue is beyond me.

Its not the valve... At this point I have changed the entire on/off to one pulled from a working valve, the powertube has all been changed, changed the sear, the bolt/spring, and have adjusted the trigger rod length. Air tanks have all been hp, I have gone through 3 tanks full of air trying to fix this.

Oh, BTW The valve works in a different body...

When the trigger is pulled, it is firing several times and sometimes giving a fire on release of the trigger as well.

Am I missing something? This is driving me nuts. Is it anything in side the valve? reg seat? ARGH!?

[Sumthinwicked]

remember the sear pin length is differant than on a micro than a ule or other mag might be a good place to start

[Coralis]

you will probably have to adjust the trigger rod , its been awhile since i had to mess with mine but i think that's what i had to do when i first got my micro.

edit just reread and saw where you adjusted the trigger rod do you have another trigger frame try swapping those out . Does this have an benchmark frame now that i remember i had quite the time sorting out my mag when i first switched to micromag about 10 years ago

[flyingpootang]

Sounds like the HES magnet is at the edge of it's activation point. Try to screw it inwards (towards the frame) a little. Are you using the Xmod software? If so then you can also try to raise your FIX......LMK when you guys want to get together and play again....

[Coralis]

Sounds like the HES magnet is at the edge of it's activation point. Try to screw it inwards (towards the frame) a little. Are you using the Xmod software? If so then you can also try to raise your FIX......LMK when you guys want to get together and play again....

uh mispost ?

[Sumthinwicked]

yea im thinkin LOL

[BigEvil]

Those things all have way different specs from normal AGD compliant parts. PM Tracy and see if she can provide you with on/off pin and trigger rod length specs. Sounds like the problem is in there.

Also take a look at your sear and sear axle pin for wear.

[Coralis]

one other thing you can do is too take the grips off of the frame and air it up and shoot it a couple of times and look to see if anything is hanging up.