Pneu Problems

[DeuceSV]

I have an intelliframe that is pneu'd.

The LPR is set up fine, and so are the internals in the frame... But when I pull the trigger, the piston DOES push onto the sear with quite a bit of force, pressing the sear into the valve... but my marker just won't fire.

I'm sort of lost, because I've upped and lowered the LPR to the max, and I've also upped and lowered the X-valve velocity to max and low... still nothing. I can hear the air escaping, which is pushing the piston into my sear, but no fire from the valve.

Any ideas?

Thanks,
Jason

[xero28]

I had a similar problem when I was putting together my Pneu. The MPA-3 (piston) was back just a little too far and it wouldn't allow the gun to fully cock when it was gassed up. Make sure there is just a tiny bit of space between the piston and the sear when it is gassed up to allow the gun to completely cock. Hope that helps.

-X