Hi,
Recently i replaced all the o rings in my classic valve. I replaced them because after a fast stroke of firing the gun would stop shooting. I followed the valve diagram which appears in the AGD web page in the process of installing the o rings so i think everything is set up properly. The problem is that today I went to play with some friends and I was very excited with my gun new o rings, but once there she didn't fire. It was like she didn't have enough pressure. I was using a 20 oz. Co2 tank. When I pressed the trigger, she would fire like if she was gassed out, but the tank was pretty full, then after a few strokes she would start throwing gas from the barrel if i held the trigger pulled. I've checked the valve diagram again and everything is in place. If someone can help I'll be very glad.
Recently i replaced all the o rings in my classic valve. I replaced them because after a fast stroke of firing the gun would stop shooting. I followed the valve diagram which appears in the AGD web page in the process of installing the o rings so i think everything is set up properly. The problem is that today I went to play with some friends and I was very excited with my gun new o rings, but once there she didn't fire. It was like she didn't have enough pressure. I was using a 20 oz. Co2 tank. When I pressed the trigger, she would fire like if she was gassed out, but the tank was pretty full, then after a few strokes she would start throwing gas from the barrel if i held the trigger pulled. I've checked the valve diagram again and everything is in place. If someone can help I'll be very glad.
Comment