pnuemag help

[crazyjoe12]

so my pnuemag was working great and it seemed to just stop. when i air it up the lpr leaks and when i adjust it to stop leaking then the gun will not fire. the trigger starts to work when i turn the lpr down or up but the gun still wont fire and the lpr leaks. any help would be apreciated. could it be that i blew something in the lpr when i hooked my adj tank up if the pressure was too high?

[TwilightG]

make sure you didn't burst a hose

Pneumagger gave me some good advice for my pneumag... hold the trigger when airing up. The LPR may not regulate fast enough when first pressurized and opening the MSV will help with the potential overpressure.

[crazyjoe12]

well ill have to try that but none of the hoses burst.

[crazyjoe12]

still having no luck

[flyingpootang]

What kind of LPR is it? If it comes apart clean it. lube it, and inspect the internal o-rings...

[suaze]

I've have similar problems when my msv-2 is tighten with the arm slightly depressed by the trigger rod. It leaks air and doesn't do a damn thing. Fixed by moving the msv-2 further back with a little slack.

[crazyjoe12]

its a jackhammer lpr and ok ill try that stuff out see if it helps.


thanks
Joe

[crazyjoe12]

ok so it was a disconnected hose hah, but im still having the problem with the lpr leaking in order to get the gun to shoot. so what should i do, could it be a bad o ring or something within the lpr? should i take it apart and look around?

[Dend78]

ok so it was a disconnected hose hah, but im still having the problem with the lpr leaking in order to get the gun to shoot. so what should i do, could it be a bad o ring or something within the lpr? should i take it apart and look around?

where is the leak coming from?

[crazyjoe12]

out of the adjusting screw.

[flyingpootang]

Sounds like the piston o-ring tome...

[Dend78]

Sounds like the piston o-ring tome...

sounds about right to me as well

[crazyjoe12]

ah ok thank you. ill have to take the lpr apart and change the piston o ring then

[Dend78]

ah ok thank you. ill have to take the lpr apart and change the piston o ring then

if you got the rings while its apart might as well do em all

[crazyjoe12]

ok so i have it appart and well all the o-rings look fine...? this is the first time ive ever taken a lpr apart, so im not sure why its leaking. im confused help me