bolt size issue with bodies

[madrox68]

ok so if classic, micromag, and rt bolts are interchangable as far as bodies are comncerned then how come how comr the rt bolt wont fit in my classic or ptp micomag 2000 body?

see i tried dropping my rt bolt in my micro and it doesn't go all the way in. its short by abput a half inch from going all the way in. rt drops into a classic body but gets stiff about the same piont but you can get it all the way in if you put some pressure to it.

[Coralis]

I had a similar issue with my level 10 bolt and my micromag, 20 mins of work on the bolt with a piece of emery cloth and it works fine now

[secretweaponevan]

Will the valve fit in without the bolt?

If so, you may need to deburr the washer inside the body that the bolt has to pass through.

[madrox68]

will not fit with either the bolt or the reg section attached so we isoloted that it is the valve that is the issue. i guess the next step is to ask if anyone has ever tried fine grit sanding the valve section of a mag valve and how thick are they. i know i should have alot of meat to play with but want to be on the safe side ya know

[MANN]

I had the same problem a while ago. PTP had a few problems with some of their bodies at one time apparently. The pressed in washer/feedneck that PTP uses is/was the problem with mine. I used some fine grit sandpaper, and was able to sand it to fit.

http://www.bigevilonline.com/showthread.php?t=1477