What sear and sear pin for Micromag clone

[Big_Magnum357]

As title says. What sear and sear pin do i need for my micromag clone project. It has a angel ball detent. The sear pin hole does not appear to be threaded.

Thanks

[secretweaponevan]

As title says. What sear and sear pin do i need for my micromag clone project. It has a angel ball detent. The sear pin hole does not appear to be threaded.

Thanks

Well, if it is like my Micromag 2000, you need a Micromag RT Sear Pin. You might be able to get one from PTP.

The hole on mine is threaded a tiny bit all the way at the bottom I think. I can check after work if need be, as I haven't had the sear pin out in a long while.