I am pretty much an idiot. I picked up a new 48/45, came in today. I immediately spun it on the emag and proceeded to put some balls through it. first few went okay then I started with the rapid fire. Every third shot would dribble out. What the heck I said to myself. I disassembled the marker. Did not see anything off hand so I re assembled it and tried it again. Same thing. Then I noticed it would not fire in mech mode. Disassembled it again and reassembled it. Same thing. Argh!!
While looking at the freshly reassembled maker and tank it hit me. This little gem has a myth regulator on it. Smack right to the forehead.
I actually picked it up for my secondary setup so when I take friend out to play with me I have two complete guns. My second gun is an invert mini which, like I said to myself when I order the tank, will take the myth reg no problem.
Crisis averted, almost. 48/45 is shorter then my 45/45. I prefer the extra length on the mini and can deal with the shortness on the mag; but the regs need to be swapped, which leads me to my question.
What is the procedure to remove and reassemble a reg from a tank? Never done it before and want to get it right the first time.
While looking at the freshly reassembled maker and tank it hit me. This little gem has a myth regulator on it. Smack right to the forehead.
I actually picked it up for my secondary setup so when I take friend out to play with me I have two complete guns. My second gun is an invert mini which, like I said to myself when I order the tank, will take the myth reg no problem.
Crisis averted, almost. 48/45 is shorter then my 45/45. I prefer the extra length on the mini and can deal with the shortness on the mag; but the regs need to be swapped, which leads me to my question.
What is the procedure to remove and reassemble a reg from a tank? Never done it before and want to get it right the first time.