Super Short trigger pull?

[ThaBobsta]

It is so short that when I turn on the safety it doesn't work....


I was told threr should be some play on trigger.... but the trigger isn't stock... its the RPG Blade trigger. Anyway this thing must shoot 10-20 bps... I mean it RIPPS!!! But no safety and that short of a trigger pull.... could I be doing Damage? Or how can I adjust it?

[secretweaponevan]

It is so short that when I turn on the safety it doesn't work....


I was told threr should be some play on trigger.... but the trigger isn't stock... its the RPG Blade trigger. Anyway this thing must shoot 10-20 bps... I mean it RIPPS!!! But no safety and that short of a trigger pull.... could I be doing Damage? Or how can I adjust it?

Screw the trigger rod into the sear clevis a little bit. With the marker gassed up and the safety on, there should be a tiny gap between the back of the trigger and the tip of the trigger rod.

[Looper]

AGD Spec for the trigger rod is 1.985"

[ThaBobsta]

Screw the trigger rod into the sear clevis a little bit. With the marker gassed up and the safety on, there should be a tiny gap between the back of the trigger and the tip of the trigger rod.

MMMK... I'm a first time owner... please explain?

EDIT: Mainly my other question


could I be doing Damage?

[Looper]

MMMK... I'm a first time owner... please explain?

EDIT: Mainly my other question

could I be doing Damage?

Yes, to the lip of your bolt where the sear catches the bolt.
Use a set of digital verniers to measure the distance from the back leg of the sear to the tip of the tigger rod. It should be approx 1.9850" to be in AGD specs. Your aftermarket "RPG Blade trigger" is made to AGD specs so use the same measurements for that also.

Does this marker have a ULT, Ultra Light Trigger, kit install? Sounds like you may have too many shims installed.

[ThaBobsta]

No it doesn't have the ULT.... I have one in the package but when I asked about the On/off(ULE installed?) he said (I have an EMag Valve) "nope. that's the on/off that came in my x-valve which is supposedly the stock on/off"

Also... it has a Level ten and was tuned by (TunaMan?) here on AO.

Edit:

I do not have digital Verniers, can i get away without it? (Trial and error via tape measure?)

[ThaBobsta]

Ok UPDATE:


I found out the problem...after close inspection, and sear measuring etc, it was just the bloody trigger pin! So problem solved, and she still shoots like a beast.