I am experiencing alot of ball chops since adding a hyperframe. I am using an xboard revvy. My friend has a powerfeed and has very few chops is this the route I should be taking??
-
-
center feeds suck on mags due to all the blowback you need a power feedZ-griped, warped, retromag with super bolt, and warpleft polished body, freak kit and flatline 3k -
try gettin your hands on the longnose bolt....
that design should help reduce the blowbackVirus, King of the Basement Trollz has spoken
Comment
-
set your bps on the hyper around 10 or 11, youll have a hard time getting up there somtimes but if you ever exceed that atleast you wont chop.AO #765
CCM Series 5
Prerelease Impulse
Hyperframed Warped Mag w/flatline tank
Feedback.
Good to know that somone of Tom's status seeks "relief" from a sport he helped create. A sport now ruled by a single patent.Comment
-
Xboard?
Dude, as far as I know you have a standard 12 volt revy. I'm sure your buddy has the x board in his. As far as you chopping balls and your friend's gun working flawlessly, sounds like simple user error. Why don't you try an Angel, I hear those are dummy proof.Comment
-
Re: Hyperframe with vertical feed Minimag is it possible??
one absolute way of avoiding blowback....the halo hopper...has a blowback trap.....check it out....Originally posted by masterblaster
I am experiencing alot of ball chops since adding a hyperframe. I am using an xboard revvy.Comment
-
How fast are you shooting? You should be using an extended nose bolt, and not exeding about 11bps because of the loader speed.
Sometimes the things just chop too, and have somethign wrong with the frame itself. The mainbody itself should'nt make much of a differance thought. Was it chopping at all before you put the new frame on?
Comment
Comment