intelliframe problem....HELP please! (AGD)

[alex1841]

today i went to go test my new intelliframe at the field and was having a problem......it wouldnt shoot! i think it might be my trigger rod but not sure? what is the right length of the rod suppose to be?

thanks,
Alex

[jah871]

can you give us a little more detail tna it didnt shoot? did the trigger rod cock? was your tank filled? have you messed with the trigger rod legnth?

[alex1841]

my bad! i knew i forgot something.

a long time ago when i first got my mag i screwed with the rod a little bit. the air in the gun was fine. it gassed up perfectly and the rod was pressing against my trigger like it was suppose to but when i pulled the trigger it would do nothing. i cant figure out why. my only guess is that the trigger rod might be too short or something unless my on/off i screwed but i checked every thing in the on/off and it all looked good. thats why i asked for the right length of the rod.

thanks,
alex

[BlackVCG]

The correct trigger rod length from the back of the sear arm to the tip of the trigger rod is 1.980" If you don't have calipers, adjust it so that when it's gassed up there's about a 1/16" gap inbetween the tip of the trigger rod and the back of the trigger. If there's no gap, it's too far forward.

[Bonx0007]

This is gonna sound stupid but I have to say it. Was the safety on?

[KamikazePenguin]

was your velocity high enough? when you pull the trigger will the rod move back at all or just move back and depress the rod without firing?

[alex1841]

i got it

i figured it out this past weekend. it was the velocity. i was cleaning my internals one night and forgot about turning the velocity up like a dumba$$. thanks though for your help.