2 Questions

[derfalpha]

1) As far as I can see, there is only 1 valve being manufactured. The X-Valve. Is this true? Where can I get older valves?

2) What are the main Automag shops around? As far as I know, I have Tunamart, The Mag Smith and the AGD site bookmarked.

Thanks!

[theGOLDENchild]

You can get some AGD parts at paintballgear (action village).

[rawbutter]

You are correct about the X-valve. You can only find older valves at BTS forums.

[derfalpha]

Damn, X-Valves are not cheap. I hope the wholesale price is very different to the retail price.

[flyingpootang]

There are plenty of valves around. If you want the Xvalve performance without the price you can always get a Emag or RT valve for 1/2 the price. The only differance is thier 1/2 aluminum 1/2 stainless steel.
Classic am/mm w/L7 bolt 40-50
Emag/RT 80-100 w/L7. Add 10-20 for a L10 bolt

[derfalpha]

I can't get hold of 20 classic valves though, can I? They're not being manufactured.

[flyingpootang]

I can't get hold of 20 classic valves though, can I? They're not being manufactured.

New? Probably not, but if you put out a want to buy ad for the right price I'm shure you'll get 50 in a couple of days...

[Tunaman]

I can't get hold of 20 classic valves though, can I? They're not being manufactured.

How many do you want? I have plenty.

[derfalpha]

Well, I need to know the price for 1, 10 and 20.

No bolt, no bolt spring. Just the valve minus powertube cap.

[derfalpha]

Oh and given they're not being manufactured. What kind of supply is there?

E.g. Do you have 500 for 3rd quarter next year?

[flyingpootang]

Oh and given they're not being manufactured. What kind of supply is there?

E.g. Do you have 500 for 3rd quarter next year?

You need 500 for the 3rd quarter of next year I think most people who posted in your thread are trying to help you out. If you just want to get attention that your not getting at home go post a nonsense thread on PBN and stop wasting everyone's time.....

[derfalpha]

You need 500 for the 3rd quarter of next year I think most people who posted in your thread are trying to help you out. If you just want to get attention that your not getting at home go post a nonsense thread on PBN and stop wasting everyone's time.....

I beg your pardon?

If all goes well, I will be producing a marker next year.

[flyingpootang]

I beg your pardon?

If all goes well, I will be producing a marker next year.

My bad. After reading all of your 21 post asking what this is for and can this be replaced with that, going from asking about if classic valves are still being manufactured, then needing 1-20, then changing to 500 vlaves by the 3rd quater of next year for a marker that your going to produce does seem to be a bit out there. I can't wait for the pre-order