help wit boo yah..............................???

[wicked_mag]

OK i basically figured i havta install those little parts that came with it and take that one piece of the sear thing, but there are these two paper circle things that came with the elcd grip i dunno what to do with can someone help me out?

[2UnREal]

You mean washers or teflon O-rings?

[wicked_mag]

there like this O sept a size of a quater and likr a sheet of pape

[wicked_mag]

plz help!!!!!!!!!!!!!1

[markhauguel]

I got those too and they are still sitting in the bottom of my tool box. Never found a use or anyone that knew what they were for. I think they might be spacers to add to their bumper to get it the right thickness (who knows) I have never needed them yet though. I kept the blue bumper that was in my gun and put the clear one that the grip came with with the washers in the tool box. you will need to use the new on/off that it came with to get it to work right. The stock one didn't work for me. Good luck I am sure that there are a lot of those washers sitting around.

[wicked_mag]

bumper????

[markhauguel]

yea the bumper is a rubber washer that goes on the power tube before the bolt slides on. My grip came with a new one that was clear. I didn't use it because it was thinner than the blue one on my gun. Still have it though. I never wore much on the bolt but I have gone through a sear in about a year.

[wicked_mag]

i got the on off pin thing stuck in the valve how do i get that out, also do i havta use the two parts that come with the elcd frame the new on off???? cuz it dosn't wanna go back together when i put those two in there? what do i do, can anyone actually write out how i'm supposed to do it? plz help soon!!1

[markhauguel]

You have to use something like pin bent over a little on the end and get it to hook in one of the holes in the center and pull it out. Also try just smacking the valve in your hand and see if it comes out, that is good enough most of the time. There is nothing holding it in except maybe oil and a close fit. I hope this helps, good luck.