Questions about X-Valve/CO2...

[cmosser502]

I know your not supposed to use CO2 with an X-Valve but I was wondering if I could use 12 grams on a pump mag I'm making... I figure your not supposed to use CO2 sue to the intended high ROF of an X-Valve but with the pump it would be a relatively low ROF, shouldn't get too cold. Anyone try this before?

Thanks,

Cole

[automagmasta]

it would probly work, but I dont reccomend it. if you want a small tank get a 13ci tank.

[maniacmechanic]

Yes i'm sure it has been done , just saw one on here the other day somewhere

[cmosser502]

ive got a 13... i just wanna run a bucket changer up front... ill give it a shot.

[Tunaman]

It will ruin the valve. If you freeze the red silicone oring sealing the powertube repeatedly it will fail. You don't want to do that. Get a cheap classic valve and be done with it.

[cmosser502]

ill take your word for it... compressed air it is.

Cole

[cmosser502]

any where I can get one new?

[secretweaponevan]

Bucket changer or 13ci ?

[cmosser502]

Neither! I was talking about the classic valve.

Thanks,

Cole

[secretweaponevan]

Neither! I was talking about the classic valve.

Thanks,

Cole

Oh, hehe. The BST here, on MCB or on Ebay. The only thing that really wears out is o-rings, so any one you get will perform like new after 5 bucks in rubber.

[Tunaman]

any where I can get one new?

Sure. Email me. [email protected]

[cmosser502]

i may within the next week. First I have to get the rail and ASA I ordered from you and send it to warpedmephisto for milling.

Cole