Lvl 10 on old mag/shoot down

[painter1009]

Hey everybody

so i have a 68 automag. from before it was classic.
in another deal i got a rt that ended up ****ting the bed on me so i took what i could use from it and put it on the 68, being the intelli frame and lvl 10 bolt.

for the lvl to all i did was put that as the new bolt in my gun, is this right? i read about people speaking of shims and carriers in conjunction wiht the lvl 10 but i dont think i have anywhere to use those?

i have used it in its current state and it has ripped for me before but i am just wondering if there are any precautions i should take/if i can or should adjust it in any way.

also im leaking out the back but from what i have read that is a piston reg assembly issue. i have considerable shootdown as well, reading my guage it starts around 1000 psui, a lil higher and pressure drops like about 100-200 psi with each shot. it comes back quickly when i stop shooting but when i fire off like 6-7 shots bursts it slows way down and wont work until it has recharged.

are these in anyway related and how do i get consistent pressure?
im running on co2 thru a wdp ergo reg and that is allowing maximum pressure into the gun currently

[Wanta B Sniper]

http://automags.org/forums/showthrea...hlight=x-valve

http://automags.org/resource/level10/index.shtml

Click those links and study the bolt parts of the diagram & read the installation guide.

Leaking out the back is likely because your reg piston cannot handle the amount of pressure needed for the LvL 10, or it could be a bad reg seat.

For the shoot down try cleaning out your valve.

Hope that helps.