Trigger Pin Size

[georgeyew]

I need to replace a trigger pin on my mag frame and I have no idea where to get one or what size to get. So please forgive me if this is a stupid question.

And is there a way to modify the pin so that it does not need to be punched out?

[secretweaponevan]

I need to replace a trigger pin on my mag frame and I have no idea where to get one or what size to get. So please forgive me if this is a stupid question.

And is there a way to modify the pin so that it does not need to be punched out?

IIRC, it is 1/8".

Sure. Drill a tiny hole from the top of the frame down over the trigger pin hole. Drill a hole in the trigger pin. Drop a very small diameter rod (paperclip?) down the new hole in the trigger frame, through the hole in the new trigger pin.

[georgeyew]

Thanks for the quick reply.

Off the top of your head, any idea what the width is? And I should be able to get them at a hardware store correct?

[secretweaponevan]

Thanks for the quick reply.

Off the top of your head, any idea what the width is? And I should be able to get them at a hardware store correct?

Depends on the frame. Stock might be 3/8". I have used the butt end of a drill bit before for the pin.