ULT help

[pbjunky99]

Ok I looked in the ULT thread and found some one that had the same problem I have but noone gave a solution so here we go.

1. My mag is leaking from the ULT. I have swaped all the o rings and it wont stop.
2. My trigger sticks quit offen. I have tried adding and removing shims but it dosnt help. After a few shots (any where form 2-20) it will stick back and not move forward again. This happens in single shot and rting.
3. Noticed that when I add/remove shims that the ULT dosnt tighten upnot sure if that right or not.
4. Level 10 dose stick at times but resets properly when I test it.

Set Up
X valve
ULT? w 6 shimms
Level 10 factory set

[Wanta B Sniper]

Hmm, well first move up one carrier size for the LvL 10. Once that is properly tuned we will focus on the ULT. Not sure of what would cause it, you say you have replaced every o-ring.

[Coralis]

check to make sure you dont have a bent ult on/off pin. also check the little black oring in between the halves its its damaged it will cause problems