emag rail sear pivot

[paintball72]

A couple weeks ago I got my first emag rail and was going to put it on my marker when I found that it didn't have the slot cut into it for the sear pivot (bar that goes through the sear for it to pivot on) to go. Instead there is a threaded hole on the right hand side of the rail that goes through to the other side of the rail but doesn't exit (if that helps at all) I asume that is all normal but where can i find a proper sear pivot for an emag rail?

[maniacmechanic]

here ya go

http://store.airgundesignsusa.com/index.cfm?fuseaction=catalog.prodInfo&productID=154&categoryID=24

[athomas]

Yeah, the emag/retro mag sear axel is different than the automag sear pin that sits in a slot. The hole through the emag sear and the retro mag sear is smaller than the hole through the automag sear, plus the emag and retro mag sear have a bushing attached for smoother operation.

[paintball72]

thanks