Assembly of pump mag...

[eelpout]

I am about to assemble a pump mag. The body and rail is being machined by Warpedmephisto and I have a Cerberus Pump Kit to put together. I have never put ont together and I know that there are instrcutions I can find on this forum. What I need is advice in what to look for so I can prevent getting into spots where I don't want to be. I have not worked on Automags for years.

Thanks in advance,
Jim

[Smoothice]

http://haveblue.org/tech/automag/index.html

http://haveblue.org/tech/automag/pump.pdf

[flyingpootang]

There is not too many things that can go wrong, but some people find it difficult to tune their pumpmag
(1) If it's hard to pump where you have to slam it back: Adjust the pump rod length.
(2) If you feel your pump rod scrapping near the end of the stroke and it's hard to pump: Your pump rod is sliding underneath your bolt. Adjust it by bending it towards the bolt a little bit at a time.
(3) If your gun shoots semi: You can either get a new wave spring from jay8541 AO or rainmann229 MCB. Its a good idea to remove your wave spring when not using your Pmag