Dis-assembling Benchmark trigger frame?

[Konigballer]

Hey,

I'm trying to get some parts ready to send off to be anodized and I'm having trouble with my Benchy frame. I can't figure out how to get out the trigger pin to remove the trigger from the frame. It's resisting being tapped out with a hammer quit well. I also can't figure out how to get the safety out. Anyone have any suggestions?

Thanks

[BiNumber3]

the saftey needs a very small allen wrench, smaller than .050 (smallest one on my Husky set)

as for the pin, most frames i've used you hit it from the passenger side of the frame, tho someone may have reversed it.

[luke]

here you go>

http://www.lukescustoms.com/page0025.htm

[Konigballer]

Luke with the save! Thanks