Hyper Flow 301 Adjustable Reg Problem

[jtamm]

I've got a Hyper Flow 301 Adjustable Reg that is no longer adjusting. It seems to just output the tank pressure. Any ideas what could be wrong?

[secretweaponevan]

I've got a Hyper Flow 301 Adjustable Reg that is no longer adjusting. It seems to just output the tank pressure. Any ideas what could be wrong?

Something isn't sealing. I've never seen one of those regs, but there are only a handful of reg designs. Can you take it apart? If so, look for the broken part/leaky o-ring/bad seal.

[BigEvil]

Bad reg seat. Good luck trying to get one. I think someone in the dealers forum was trying to acquire some Centerflag parts so you might want to check with that person.

[jtamm]

Took it apart, didn't see anything broken or worn out. Are there any pictures or diagrams of regulators out there?

[chill will]

Here is a link to a write up done on some of centerflags other tanks. Its the best I can do right now due to the office fillters on the computer.

WARPIG

[chill will]

Bad reg seat. Good luck trying to get one. I think someone in the dealers forum was trying to acquire some Centerflag parts so you might want to check with that person.

LINK TO DEALER

[jtamm]

Ah, awesome. Those pics were exactly what I was looking for. Thanks!

[jtamm]

No luck. Took off the regulator body and checked the kevlar pin. Reseated everything and put it back together. it held at 300 psi. Cranked it up a bit to 600 and it seemed to hold. Fired off a shot and the pressure started to climb to over 1k. After every shot it resets to 600 and just climbs. I'm guessing it's a problem with the pin?