grip screws threading

[jonmcfatty]

What thread are the grip frame screws. I went to home depot and bouth m5x.80 and they don't fit

[atech2]

What frame do you have? One that I'm fairly sure of is it's not metric, don't recall any mag frames with metric threading. If I had to guess off thre top of my head, I'd start with 6-32.

[jonmcfatty]

I have an emag. I'm not too technical but I tried threading the stock screw into the little display that they had and it fit into the size in my first post. But when I got the new bolts home they only threaded in about 1/8th inch into my emag. That does make sense though - i don't think agd would use metric threads. FYI i need them because I just bought a warp feed and the bracket is too thick for the stock bolts to still fit. Thanks

[Ando]

Ya...I can't remember off the top of my head. Go back down there with one of the stock screws and see which one is right. I know Lowes has a board with male and female inserts so you can see which thread type you have. The Lowes down where I live have a better hardware selection then the Home Depot so try them instead.

[atech2]

I'm a little confused. Do you mean bottom line screws. I was thinking grip screws. Standard bottom line are 10-32. (I will check and verifiy that).

[maniacmechanic]

I'm a little confused. Do you mean bottom line screws. I was thinking grip screws. Standard bottom line are 10-32. (I will check and verifiy that).

Correct

[atech2]

Comparing my 10-32 and M5-0.80 taps, they are very close. The stores display must have very worn out threads.

[jonmcfatty]

Yes the ASA threads. great I really appreciate all the help i'll run down tomorrow and pick some up. really thank you