Morlock board problems in my hyperframe

[big poppa fluff]

I traded a gun awhile back for a x'ed ulemag with a morlock hyperframe. I sent the board to get reflash but it still isnt shooting right. Sometimes it shoots sometimes nothing, its like the noid wont let the air through. It might be the setup of the board but i lost the manual for it so im screwed. I would be greatful if anybody could send me a copy of the manual or even how there morlock board might be set up.

Thanks,
BPF

[BigEvil]

Oppps -'hyperframe'


Check to see if the solenoid moved. It should be all the way BACK.

Which version of the software do you have? The manuals are on the 'new' Tag sight. IF not, PM me later I think I have them all at home.

[big poppa fluff]

Oppps -'hyperframe'


Check to see if the solenoid moved. It should be all the way BACK.

Which version of the software do you have? The manuals are on the 'new' Tag sight. IF not, PM me later I think I have them all at home.

I ment the electronic noid the pneumatic noid works fine. I,ll check the tag sight

[BigEvil]

Wait a sec, what kind of set up is this? Is it a regular hyperframe with a Predator Morlock board or is there something else going on in there? Should be one round 'pancake' solenoid.

[big poppa fluff]

Wait a sec, what kind of set up is this? Is it a regular hyperframe with a Predator Morlock board or is there something else going on in there? Should be one round 'pancake' solenoid.

It electropneumatic( LPr reg too a elec,. noid then to a pneumatic noid to trip the sear)

[big poppa fluff]

I just checked the LPR and it works fine its just the electro noid isnt letting air through.
I dont know what version the board is But it is green, If you need a pic of It I can get it.

[big poppa fluff]

I got the gun working it wasn't setup for a hyperframe and...... it needed a new battery. I'm a idiot.