Help my EMags please

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Epic_Scotsman
    Registered User
    • Feb 2008
    • 183
    #1

    Help my EMags please

    OK so I have these two emags with a bevy of problems and electros are beyond me.

    I have been unable to get a hold of tunaman or buddy at modmymag.com

    Who wants to work on my emags? You will be paid handsomely.

    I believe one of the boards is fried. So if I get one set of woring lowers out of this I will be happy.

    Oh yeah I live in Canuckistan.
    Tags: None
    • flyingpootang
      Magtechian with X disease

      • Dec 2005
      • 2276
      #2
      Did you check if the ground/board screw is snug, change batteries, check connections? It may be a simple fix, but if not I'll work on it...

        Comment

        • Jaron
          Too much time
          • Jul 2007
          • 101
          #3
          Care to elaborate a bit on your problems? What are your E-Mags doing or not doing? What tests, if any, have you tried to run on them so far?

            Comment

            • Epic_Scotsman
              Registered User
              • Feb 2008
              • 183
              #4
              This is all without Air
              On this emag I just found a little magnet magnetized to the bottom trigger one I took it off and the marker lit up.
              Ok emag one will light up with both batteries and has AGD 3.2

              TRG OFF
              SHBF 4
              TS 0
              SPS 19
              ACE 0

              I click the trigger in e mode and nothing?

              Emag 2

              lights up with AGD 1.37
              15:00
              SHTS 00
              TS550027
              SPS 16
              Gam.T 15

              now in emode if I move the solenoid up and pull the trigger clicks down
              and if I pull the trigger when the solenoid is down I can feel it trying to close

                Comment

                • flyingpootang
                  Magtechian with X disease

                  • Dec 2005
                  • 2276
                  #5
                  You need to re-install the magnet it actuates the HES, but you need to find out which polarity will activate it either north or south. For the original problem it sounds like the HES magnet (the one you removed) was too close to the activation point. There are 2 ways you can adjust it first by the HES magnet screw located on the bottom of your trigger and sendonly by the set screw on top of your selector switch (have to remove lowers to access it).....

                    Comment

                    • Epic_Scotsman
                      Registered User
                      • Feb 2008
                      • 183
                      #6
                      there is still a magnet in the trigger(well two top and bottom of both emags)

                      and you think this polarity thing is the problem with both?

                        Comment

                        • Jaron
                          Too much time
                          • Jul 2007
                          • 101
                          #7
                          Polarity on the top doesn't matter so long as both the trigger and frame magnets attract each other. However the trigger magnet will trip the HES sensor differently depending on whether the north or south poll is facing it.

                            Comment

                            Previous template Next
                            Working...